Gree GMV-36WL/A-T(U) - Page 72

DC Inverter Side Discharge VRF Ⅱ for North America
70
3.5 Fixing and damping of unit
The outdoor unit shall be fixed with 4 M12 bolts and closely contacted with the
foundation. Otherwise, big vibration and noise will be caused.
The outdoor unit shall be fixed firmly. The rubber board with thickness over 20mm or
corrugated rubber damping pad shall be applied between the unit and foundation.
3.6 Outline dimension and position of installation hole
When carrying the outdoor unit, hang the unit in four directions with two sufficient ropes.
In order to avoid excursion from the center, the angel of ropes must be smaller than 40º
during hanging and moving.
Unit:mm（inch）
Model
A
B
C
D
E
GMV-36WL/A-T(U)
GMV-48WL/A-T(U
900
（35-7/16）
340
（13-3/8）
1345
（53）
572
（22-1/2）
378
（15）
GMV-60WL/A-T(U)
940
(37)
320
(12-9/16)
1430
(56-1/4)
632
(24-7/8)
350
(14-7/8)
3.7 Installation space requirement
If all sides of the ODU (including the top) are surrounded by walls, process according to
the following requirements for installation space: