GMV5 DC INVERTER VRF UNITS SERVICE MANUAL
306
Troubleshooting procedure is as follows:
1. Check network lines of the server and client and make sure they connect to the LAN;
2. Ping the IP address of the server on the client (for detailed operation, refer to the maintenance
chapter). If Ping succeeds, they can normally communicate; otherwise, the software cannot be used.
c. Enter the default username and password of the Administrator and click ―Login‖. If the following
system homepage appears, system debug succeeds and the software can be used.
Default username of the Administrator: admin; password: basstart
This debug method is for the Administrator only. Other roles are not allowed to use this method.
To Next Page
Loading...
