Removing Collected Water
19
1. Remove the rubber plug at drainage port.
2. Fix the drainage pipe clip on the right of rear side plate near drainage port with
a screw.
3. Put the drainage pipe into drainage port and screw it up, and then bind it with
pipe hoop.
drainage port
drainage port
drainage pipe clip
screw
Note:
When using the continuous drainage option from the bottom hole, install
drainage pipe before using, otherwise poor drainage will affect normal
operation of the unit.
There are 2 ways to remove collected water:
■
Instructions for drainage pipe installation as follows.
Use the continuous drainage option from the bottom hole
1
pipe hoop
drainage pipe
drainage
pipe clip
pipe hoop
rubber plug
To Next Page
Loading...
