25
Installation in a double-hung sash window
Installation in a sliding sash window
9. Close the window sash securely against the Window panel.
window sash
10. Cut the sponge A to a proper length and seal the gap between upper part of inner
window sash and outer window sash.
vertically.
11. Fix the inner window with window bracket and screw, so that it can not slide
sponge A
outer window
inner window
plastic window
wooden window
window bracket
1. Install rear clip — aim the rear clip(upper) at the rear clip(lower),fix them together,
press the clasp forcibly in to the groove.
clasp
rear connector (lower)
rear connector (upper)
2. Clamp joint B+C into the inner side of window panel along the direction of arrow.
To Next Page
Loading...
Need help?
General
