39
Maintenance
Service Manual
Installation procedures
Accessory list
Optional accessories
(Note: some models are without the following accessories.)
Install wire hook
Install drainage pipe
Install window frame
Install heat discharge pipe and joint
pack up heat discharge pipe
Note: this flow is only for reference; please find the more detailed installation steps in this section.
Preparation before installation
Start installation
Prepare tools
Read the requirements
for electric connection
Check after installation and test operation
Finish installation
window frame (3)
wire hook (2)
screw (8) window fastener clip of rear
connection plate
sponge Asponge B(2) drainage pipe
pipe clip
rubber plugremote controller
unit
battery (2)
(AAA 1.5V)
pipe hoop (2)
joint Ajoint Bjoint C heat discharge pipe
screw (2) bolt (4) spring
washer (4)
washer (4)nut (4)protective grille (1)support (2) rain shield (1)
To Next Page
Loading...
Need help?
General
