23
Remove Collected Water: Continuous
Drainage Middle Hole Option
1
2
Remove the Continuous Drain Cap by turning it
counter clockwise, then remove the
Rubber Plug
from the spout.
Screw the
Drain Connector (included in the
package) to the spout by turning clockwise.
Insert the
Drainage Hose into the Drain
Connector
.
NOTICE:
Water can automatically empty into a floor drain by attaching a drainage hose.
ATTENTION:
When using continuous drainage option from the middle hole, place portable on a level
surface and make sure drainage hose is clear of any obstructions and is directed downward. Placing portable on
an uneven surface or improper hose installation may result in water filling up the chassis and causing the unit to
shut off. Empty water in the chassis if shut off occurs, then check portable location and hose for proper setup.
CLEANING AND MAINTENANCE
Middle Hole
To Next Page
Loading...
Need help?
General
