Air Source Heat Pump Water Heater
10
(2) Value obtained with an air temperature of 7°C and a water inlet at 10℃, as per
EN16147-2011, (EU) No 814-2013.
(3) Value obtained as per EN 12102-2008, (EU) No 814-2013.
(4) The installation of suction and backflow conduits on the heat pump lessens its
performance.
Under fast water heating mode, electric heater helps to heating water.
Please always see the nameplate for the exact data as this table is subject to
change.
3 Installation
3.1 Important hint
(1) The air source water heater must be installed by professional person
according to national wiring regulation and this instruction manual.
(2) If it needs to install and move the air source water heater, please contact
with Gree appointed local maintenance center. If the air source water heater is
installed by unappointed unit, Gree won’t take the responsibilities for the malfunction
and other problems due to the installation.
(3) If the users use the own prepared installation materials to install the air
source water heater, Gree won't take any responsibilities for all the loss due to
leakage of pipeline, drop of unit and poor installation.
(4) The water quality for the air source water heater should comply with the local
sanitation standard for the domestic drinking water. If using the water in well, ground
water or sea water, it will accelerate the consumption of magnesium rod in water
tank and shorten the service life of the unit.
(5) The water passed through the iron-exchange water softener will accelerate
the consumption of magnesium rod of water tank. Therefore, you are not suggested
connecting the water softener to the water inlet of air source water heater.
To Next Page
Loading...
