Gree GRS-2.4/D270ANbA-K - Wired Controller Installation

Air Source Heat Pump Water Heater
17
3.8 Wired Controller Installation
3.8.1 Requirements for Wired Controller Installation Locations
(1) Do not install the wired controller in a wet place or a place exposed to direct
sunlight.
(2) Do not install the unit or wired controller of the air source water heater in a
place susceptible to electromagnetic interference.
(3) Ensure that the communication line is connected to the correct interface.
Otherwise, communication will be failure.
3.8.2 Wired Controller Installation
No.
1
2
3
4
Name
Front panel of
wired controller
Screw
Soleplate of
controller
Socket’s base
box installed
in the wall
Fig. 3-3 Accessories of Wired Controller