Chapter Ⅱ Installation（5. Installation and Heat Insulation for Pipelines of Water System）
30
（5）Installation Dimension of Wiring Box
（6）Error and Solution
○
1 Please confirm if the detecting signal wire, communication wire or water level switch wire
is connected;
○
2 Take the electrode out from the water tank. Wipe each electrode metal head to remove the
impurities on the surface and then put it back to the water to see if the error is eliminated. If the
error is eliminated, please pay attention to the routine maintenance of electrode and clean the
electrode once a month.
○
3 If the error still exists when the above operation is done, please contact our after-sales
To Next Page
Loading...
