Gree GUD24W2/D-D(U) - Page 88

GREE DC INVERTER HEAT PUMP CONDENSING UNIT SERVICE MANUAL
85
Removal of Compressor
NOTE: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work Instruction
3. Loosen the
compressor’s base
connectors.
 Use a wrench to twist off
the compressor’s base
nuts.
4. Remove the
compressor from the
chassis.
 Take away the
compressor and replace
with a new one.
NOTE: When replacing
the compressor, avoid
touching the nearby
pipeline and components.
5. Install the new
compressor onto the
chassis.
 After replacing the
compressor, tighten up
the base screw nuts.