GREE DC INVERTER HEAT PUMP CONDENSING UNIT SERVICE MANUAL
86
Removal of Compressor
NOTE: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work Instruction
6. Connect the welding
interfaces of
compressor to the
pipeline.
Weld the connection pipes
of compressor so as to
connect them to the
compressor.
NOTE: When replacing
the compressor, avoid
touching the nearby
pipeline and components.
7. Connect the
compressor wires.
Connect the compressor
wires to the wire terminals
on the top of compressor.
NOTE: When connecting
the wires, be sure to
match the colors with the
corresponding wire
terminals.
To Next Page
Loading...
