GREE DC INVERTER HEAT PUMP CONDENSING UNIT SERVICE MANUAL
89
Removal of Compressor/Gas Liquid Separator
NOTE: Before removing the compressor/gas liquid separator, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work Instruction
7. Install the new
gas liquid
separator
onto the
chassis.
After replacing the gas
liquid separator, tighten
up the base screw nuts.
8. Install the new
compressor
onto the
chassis.
After replacing the
compressor, tighten up
the base screw nuts.
9. Connect the
welding
interfaces of
compressor/g
as liquid
separator to
the pipeline.
Weld the connection
pipes of compressor so
as to connect them to
the compressor.
NOTE: When replacing
the compressor, avoid
touching the nearby
pipeline and
components.
To Next Page
Loading...
