Gree GUHD series - Page 132

80DWFK6HULHV'&
,QYHUWHU6HUYLFH0DQXDO
129
Disassembly and Assembly of electrical parts box
Remark : Before removing the electric box or electric box sub-assembly, make sure that the power has been cut off.
Step Illustration
Handling Instruction
1. Remove the
backside panel
Remove the backside panel away
from the unit
2. Disconnect the
power cord of the
motor
Disconnect the motor power cord on
the main board with hands or pliers.
3. Loosen the
screws between
the electric box
and side panel
and motor base.
Loosen the screws between the
electric box and side panel and motor
base with a screw driver.
4. Remove the
electric box sub-
assembly
Ɣ0RYHWKHHOHFWULFER[VXEDVVHPEO\
upward from the middle isolation
plate.
5. Mount a new
electric box sub-
assembly
Ɣ$VVHPEOHWKHQHZHOHFWULFER[VXE
assembly to correct position
Ɣ8VHWKHVFUHZGULYHUWRIL[WKH
electric box sub-assembly to middle
isolation plate and rear side plate
according to disassembly procedures.