Gree GUHD series - Page 135

80DWFK6HULHV'&
,QYHUWHU6HUYLFH0DQXDO
132
8. Remove the
right side panel.
Remove the right side panel
away from the unit.
Removal and Installation of Gas-liquid Separator and Compressor
Remark: Before removing the compressor, make sure that there is no refrigerant inside the pipe system and that the
power has been cut off.
Step Illustration
Handling Instruction
1. Disconnect
the wiring of the
power supply of
the compressor
a. Open the cover of the power
supply box with a wrench.
b. Disconnect the power cord of the
compressor with the pliers.
c. Pull out the power supply plug of
the compressor.
2. Loosen the
screws on the
compressor
Loosen the screws between the
compressor and the compressor
base with a wrench.
3. Disconnect
the suction and
discharge pipes of
the compressor
a. Dismantle the gas-liquid separator
through heating its inlet/outlet pipe by
the means of gas welding.
b. During the welding, nitrogen
should be inflated and its pressure
should be 0.5±0.1kgf/cm
3
(relative
pressure)
c. Attention should be taken during
the heating to avoid the surrounding
objects burnt due to the high
temperature.