Gree GVA48AL-M3NNC7A/I - Page 26

Service Manual
23
Technical Information
● Under simple swing mode, pres this button can turn on (" " icon is displayed) or
turn off (" " icon is not displayed)
● When the unit is turned off by remote controller, press "▲" button and " "
● This remote controller is the general type remote controller. When remote controller receives the signal of " " , sw
ing
status is same as " " ; when remote controller receives " " , swing status is same as left&right swing OFF.
button can switch between single swing mode
" " on the remote controller will flash twice.
9
Under fixed-angle swing mode, press this button and then left&right swing status will
circulate as shown in the right figure:
● Under simple swing mode, pres this button can turn on (" " icon is displayed)
lor turn off (" " icon is not displayed) the
● When the unit is turned off by remote controller, press "▲" button and " "
button can switch between single swing mode and
" " on the remote controller will flash twice.
Under fixed-angle swing mode, press this button and
the up&down swing status will circulate as shown in the right figure:
button
8
button
no display
no display
10
SLEEP button
Under COOL, or HEAT mode, press this button to start up sleep function.
" " icon is displayed on remote controller
. Press this
button again to cancel sleep function and " " icon will disappear.After powered on, Sleep Off is defaulted. After the unit is
turned off, the Sleep function is canceled. In this mode, the time of time can be adjusted. Under Fan
DRY and Auto modes,
this function is not available.
WiFi button
11
● This function is only available for some models.
Press " WiFi " button to turn on or turn off WiFi function. When WiFi function is turned on, the " WiFi " icon will be displayed on
remote controller; Under status of remote controller off, press "MODE" and " WiFi " buttons simultaneously for 1s,WiFi module
will restore to factory default setting.
12
Pressing this button in COOL or DRY mode, the icon " " is displayed and the
Only under cooling mode and dry mode, press this button can turn on (characters
(characters of “X-FAN” are not displayed)
of “X-FAN” are displayed) or turn off
X-FAN function.
indoor fan will continue operation for a few
minutes in order to dry the indoor unit even though you have turned off the unit. After energization, X-FAN OFF is
defaulted.X-FAN is not available in AUTO, FAN or HEAT mode.
unit will be blowed
This function indicates that moisture on evaporator of indoor
after the unit is stopped to avoid mould.
● Having set XFAN function on: After turning off the unit by pressing ON/OFF
about a few minutes. at low speed.
button indoor fan will continue running for
In this period, press X-FAN button to stop indoor fan directly.
●
●
Under heating mode, press this button and the E-HEATER status will changed circularly as below:
●
Having set XFAN function off: After turning off the unit by pressing ON/OFF
button, the complete unit will be off directly.
X-FAN/E-HEATER button
Auto E-HEATER (no display)
E-HEATER OFF
( is displayed)
E-HEATER ON
( is displayed)
the left&right swing function.
and fixed-angle swing mode.
up&down swing function.
fixed-angle swing mode.