43
43
3.6 Swing Setting
Swing On: With the unit on, press “Function” to activate the swing function. In this
case, will flash. Press Enter/Cancel to confirm.
Swing Off: When the Swing function is on, press “Function” to enter the Swing
setting interface, with flashing. Press Enter/Cancel to cancel this function.
How to set the Swing function is shown in Fig.9.
Note :
① .Sleep, Turbo and Blow are set in the same way as setting the Swing
f
unction.
② .When Swing is set, press “Enter/Cancel” to go back to the setting
status or the remote control will automatically go to the setting status
after 5 sec.
Turn on the unit, without
turning on swing function
Press (Function) button
into swing state
Press (Enter/ Cancel) to
cancel swing
Press (Function) button
into swing state
Press (Enter/Cancel) to
confirm
Fig. 9 Setting the Swing Function
3.6 Activation de l'oscillation (Swing)
Activation de l'oscillation: Quand l’appareil est allumé, appuyez sur le bouton «
Swing » pour activer l'oscillation et clignotera. A
ppuyez sur le bouton
« Enter/Cancel » pour confirmer.
Désactivation de l'oscillation: Quand l'oscillation est activée, appuyez sur le bou-
ton « Function » pour accéder aux paramètres de réglage et clignotera.
Appuyez sur le bouton « Enter/Cancel » pour désactiver cette fonction.
La figure 9 illustre comment régler l'oscillation (Swing).
Remarque :
① .Les modes « Sleep », « Turbo » et « Blow » s
e règlent de la même
f
açon que le mode « Swing ».
② .En mode « Swing », appuyez sur le bouton « Enter/Cancel » pour
retourner aux paramètres de réglage, ou la télécommande reviendra
automatiquement aux paramètres de réglage après cinq secondes.
Allumez l’appareil sans
activer le mode « Swing ».
Appuyez sur le bouton «
Function » pour accéder
au mode « Swing ».
Appuyez sur le bouton «
Enter/Cancel » pour dés-
activer le mode « Swing ».
Appuyez sur le bouton «
Function » pour accéder
au mode « Swing ».
Fig. 9 Réglage du mode
Appuyez sur le bouton «
Enter/Cancel » pour acti-
ver le mode « Swing ».
00708_Owner's manual Lomo_Mise en page 1 15-03-03 14:52 Page48