4.
2.
If the outdoor unit is higher than the wall hole,
1. Remove the wire clip; connect the power con-
wall
●
● The water outlet can't be placed in water in
order to drain smoothly.
●
●
The wiring board is for reference only, please refer
The drain hose can't be fluctuant
2.
●
After tighten the screw,pull the power cord slightly
●
Never cut the power connection wire to prolong or
The drain hose can't be curved,raised and
fluctuant,etc.
connect outdoor electric wire
Step 5:
U-shaped curve
drain hose
the drain hose
can't raise
upwards.
The water outlet
can't be placed
in water
Notice
to the actual one.
shorten the distance.
The drain hose
to check if it is firm.
can't be fluctuant
The water
outlet can't be
fluctuant
nection wire and signal control wire (only for
cooling and heating unit) to the wiring terminal
according to the color; fix them with screws.
Notice
Step 6:
neaten the pipes
Fix the power connection wire and signal con-
trol wire with wire clip (only for cooling and h-
eating unit).
Notice
1.
The through-wal height of drain hose shoul
not be higher than the outlet pipe hole of in-
door unit.
Slant the drain hose slightly downwards.
Tighten the union nut with torque wrench
by referring to the sheet below.
reasonably and hidden possibly. Min. semidiam-
eter of bending the pipe is 10cm.
The pipes should be placed along the wall, bent
9
Indoor unit connection
07K、09K、12K:
LN
you must set a U-shaped curve in the pipe
before pipe goes into the room, in order to
prevent rain from getting into the room.
N(1) 2 3
L
N
POWER
blue
blue
brown
brown(black)
black
yellow-
green
yellow-green
Indoor unit connection
18K、24K:
N(1) 2 3 L N
L N
POWER
blue
brown
brown
(black)
blue
yellow-
green
black
yellow-
green
15~20
30~40
45~55
60~65
70~75
1/4''
3/8''
1/2''
5/8''
3/4''
Hex nut diameter
Tightening torque(N m)
.
To Next Page
Loading...
