14
●
●
This function is only available for some models.
NOTE
Night mode
●
●
●
NOTE
2.
1.
Replacement of batteries in
remote controller
3.
●
●
●
●
●
●
NOTICE
Under cooling or heating mode, when turning on
sleep mode and turn to low speed or quiet notch,
the outdoor unit would enter into night mode.
The
auto clean function can only work under normal
ambient temperature. If the room is dusty, clean it
once a month; if not, clean it once every three
months. After the auto clean function is turned on,
you can leave the room. When auto clean is finished,
the air conditioner will enter standby status.
When you feel that the cooling and heating effect is
poor, please press "Fan" button to other fan speed
or press "Sleep" button to exit the night mode.
The
night mode can only work under normal ambient
temperature.
This function is only available for some models.
some noise, which is the sound of flowing liquid or
thermal expansion or cold shrinkage. The air con-
ditioner may blow cool or warm air, which is a
normal phenomenon. During cleaning process,
please make sure the room is well ventilated to
avoid affecting the comfort.
Press the back side of remote cont roller
marked with " ", as shown in the fig, and then
push out the cover of battery box along the
arrow direction.
Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
Reinstall the cover of battery box.
Two-way ventilation function
●
NOTE
This function is only available for some models.
During operation, point the remote control signal
sender at the receiving window on indoor unit.
The distance between signal sender and receiving
window should be no more than 8m, and there
should be no obstacles between them.
Signal may be interfered easily in the room where
there is fluorescent lamp or wireless telephone;
remote controller should be close to indoor unit
during operation.
Replace new batteries of the same model when
replacement is required.
When you don
't use remote controller for a long time,
please take out the batteries.
If the display on remote controller is fuzzy or there
's
no display, please replace batteries.
Under turning on，press "Mode" and "I Feel"
buttons simultaneously to start up or turn off
two-way ventilation function.When two-way
ventilation funct ion is started up, will be
shown on remote controller, and the light of the
two-way ventilation system is turned on. Fan
speed will be adjusted according to the fan
speed of air conditioner.
Under turning off，press "Mode" and "I Feel"
buttons simultaneously to start up or turn off
t wo-w a y v e n t i l a t i o n f u n c t i o n o n l y .Wh e n
two-way ventilation function is started up,
will be shown on remote controller, and the
li
ght of the two-way ventilation system is turned
on. Fan speed will be adjusted according to fan
button on remote controller.
reinstall
battery
Cover of battery box
remove
To Next Page
Loading...
