12
Light button
●
LED on Auto LEDLED off
no display
LED off
no display
Press this button to control the LED status on the
displayer, the circulation change is as follow:
Energy-saving function
Function introduction for
combination buttons
NOTE
When selecting " " (Auto LED) with remote
controller, LED indicator on indoor unit will adjust
the luminance automatically according to the
ambient intensity of illumination.
ponding temperature of last setting sleep curve
and blink;
(4) Repeat the above step (2)~(3) operation, until
8 hours temperature setting finished, sleep,curve
setting finished, at this time, the remote controller
will resume the original timer display; temperature
display will resume to original setting temperature.
Sleep 3 the sleep curve setting under Sleep mode
by DIY could be inquired:
The user could accord to sleep curve setting method
to inquire the presetting sleep curve, enter into user
individuation sleep setting status, but do not
change the temperature, press "I Feel" button
directly for confirmation. Note: In the above presetting
or enquiry procedure, if continuously within 10s,
there is no button pressed, the sleep curve setting
within 10s, there is no button pressed, the sleep
curve setting status will be automatically quit and
resume to display the original displaying. In
the
presetting or enquiry procedure, press " On/Off " button,
"Mode" button, "Timer" button or "Sleep" button,
the sleep curve setting or enquiry status will quit
similarly.
Under cooling mode, press "Mode" and "Timer"
buttons simultaneously to start up or turn off ener-
gy-saving function. When energy-saving function
is started up, "SE" will be shown on remote con-
troller, and air conditioner will adjust the set tem-
perature automatically according to ex-factory
setting to reach to the best energy-saving effect.
Press "Mode" and "Timer" buttons simultaneously
again to exit energy-saving function.
Child lock function
Hold " On/Off " and " - " buttons simultaneously for
3s to turn on or turn off child lock function. When
child lock function is on, " " icon is displayed on
remote controller. If you operate the remote con-
troller, the " " icon will blink three times without
sending signal to the unit.
Under OFF status, hold "Mode" and " - " buttons
simultaneously for 3s to switch temperature
displaybetween °C and °F.
Temperature display switchover function
function
blank
No Setting
●
●
●
●
function is for limiting power of the whole unit.
Press "Mode" and "Sleep" buttons simultaneously,
the remote controller will circularly display as the
following:
Under energy-saving function, fan speed is defaulted
at auto speed and it can't be adjusted.
Under energy-saving function, set temperature can't
be adjusted.
Sleep function and energy-saving function can't oper-
ate at the same time. If energy-saving function has
been set under cool mode, press "Sleep" button will
cancel energy-saving function. If sleep function has
been set under cool mode, start up the energy-
saving
function will cancel sleep function.
●
For the model with one outdoor unit and two indoor
units, if any one of indoor units enters into power
limiting function, the outdoor unit will enter into the
set limiting power mode of indoor unit; when two
Maximum power limited under the mode is
lower than that of mode.
If you want to cancel the power limiting function,
press "Mode" and "Sleep" buttons simultaneously
till the icon in remote controller is not displayed.
When the remote controller is turned off, power
limiting function is cancelled. If you want to
activate the function, please repress "Mode" and
"Sleep" buttons simultaneously.
If the current power is lower than the maximum
power of mode, then the power will not be limit-
ed after entering into such mode.
To Next Page
Loading...
