Clean filter
2.
Clean filter
15
Spring
fastener
Spring
fastener
Use clear water to wash it or dust catcher to
clean it. If the filter is very dirty (such as grease),
use warm water (45℃) dissolved with neutral
detergent to clean it, and then put it at the shady
place to dry it.
3.
Install filter
1.
Remove filter
Press the spring fasteners at both sides in the
direction indicated by the arrows.
3.
Meanwhile, lift up the filter so that it is separat-
ed from the fasteners.
Pull the filter forward and remove it.
NOTICE: Checking before use-season
1.
Check whether air inlets and air outlets are bl-
After
cleaning, reinstall the filter in reverse order.
Push it along the guide rails at both sides and
then press the left and right edges of the filter.
Refit the filter in the direction indicated by the
arrows.
4.
5.
Do not remove the panel when cleaning it.
Check whether drainage pipe is damaged.
Check whether filter is clean.
Check whether mounting bracket for outdoor
unit is damaged or corroded . If yes, please
contact dealer.
NOTICE
●
●
in good condition.
ocked.
2.Check whether air switch, plug and socket are
Disconnect power supply.
If there're other error codes, please contact qu-
alified profess ionals for service.
Clean filter and indoor unit’s panel.
NOTICE: Checking after use-season
1.
2.
3.
Clean and maintenance
■
2.
■
WARNING
WARNING
■
■
■
■
■
Error Code
Error code
F2
E8
Please contact qualified professionals for
service.
C5, F0, F1,
Troubleshooting
U8, H6, H3,
Notice for recovery
1.
E1, E5, E6,
Check whether mounting bracke t for outdo
or
unit is damaged or corroded. If yes, please
contact dealer.
Many packing materials are recyclable mate-
Clean surface of indoor unit
When the surface of indoor unit is dirty, it is recomm-
ended to use a soft dry cloth or wet cloth to wipe it.
The filter should be cleaned every three months .
If there is much dust in the operation environme-
nt, clean frequency can be increased.
After removing the filter, do not touch fins to
avoid injury.
Do not use fire or hair dryer to dry the filter to
avoid deformation or fire hazard.
e tairporppa ni meht esopsid esaelP .slair
recycling unit.
If you want to dispose the air conditioner, please
contact local dealer or consultant service center
for the correct disposal method.
When air conditioner status is abnormal, tempe-
rature indicator on indoor unit will blink to display
corresponding error code. Please refer to below
list for identification of error code.
NOTE
It can be eliminated after restarting the unit.
If not, please contact qualified professionals
for service.
Turn off the air conditioner and disconnect the
power before cleaning the air conditioner to av-
oid electric shock.
Do not wash the air conditioner with water to
avoid electric shock.
Do not use volatile liquid to clean the air
conditioner.
Do not use liquid or corrosive detergent to clean
the appliance and do not splash water or other
liquid onto it , otherwise, it may damage the
plastic components , even cause electric shock.
To Next Page
Loading...
