Gree GWH18AGDXF-D6DNA4B/O - Disposal of Equipment Using Flammable Refrigerants

Specialist’s Manual
27
Any pictograms used should be as simple as
possible and contain only essential details.
Avoid other heat sources or direct sun light.
Attention is drawn to the fact that additional trans-
portation regulations may exist with respect to
equipment containing flammable gas. The maxi-
mum number of pieces of equipment or the config-
uration of the equipment permitted to be transport-
ed together will be determined by the applicable
transport regulations.
Signs for similar appliances used in a work area
are generally addressed by local regulations and
give the minimum requirements for the provision of
safety and/or health signs for a work location.
The storage of the appliance should be in accor-
dance with the applicable regulations or instruc-
tions, whichever is more stringent.
Avoid a place where is possible for inflammable
gas to leak out.
Marking of equipment using signs
Storage of equipment/appliances
Storage of packed (unsold) equipment
The effectiveness of signs should not be dimin-
ished by too many signs being placed together.
Disposal of equipment using flammable
refrigerants
See national regulations.
Storage package protection should be construct-
ed such a way that mechanical damage to the
All required signs are to be maintained and
employers should ensure that employees receive
suitable and sufficient instruction and training on the
meaning of appropriate safety signs and the
actions that need to be taken in connection with
these signs.
Transportation, marking and storage for units
Transport of equipment containing flammable
refrigerants.
equipment inside the package will not cause a leak
of the REFRIGERANT CHARGE.
The maximum number of pieces of equipment
permitted to be stored together will be determined
by local regulations.
to an acceptable level to make certain that flam-
mable refrigerant does not remain within the
lubricant. The compressor body shall not be
heated by an open flame or other ignition sources
to accelerate this process. When oil is drained
from a system, it shall be carried out safely.