Service Manual
Steps Procedure
4.Remove grille and panel
Twist off the screws connecting the grille and
panel, and then remove the grille.
Twist off the screws connecting the panel, chassis
and motor support with screwd-river, and then
remove the panel.
grille
panel
5.Remove right side plate
Twist off the screws connecting the right side
plate and chassis, valve support and condenser,
and then remove the right side plate.
right side plate
6.Remove axial flow blade
Twist off the nuts on blade with wrench and then
remove the axial flow blade.
Installation and Maintenance %
95
To Next Page
Loading...
