Gree GWH36LB-K3NTA5A - Page 17

14
7HFKQLFDO,QIRUPDWLRQ
Service Manual
6. button
Press this button can select left&right swing. Swing angle can be selected circularly in sequence as below:
● When selecting " " with remote controller, it’s auto swing. Horizontal louver of air conditioner will swing left&right automatically at
the maximum angle.
● When selecting "
ǃ ǃ ǃ ǃ
stop at that position as shown by the icon to swing.
● When selecting " ", it’s the circulating swing. Horizontal louver of air conditioner will swing circularly according to
the angle as shown by the icon.
7. HEALTH SAVE button
HEALTH Function:
After pressing HEALTH button, remote controller will switch circularly as below:
"HEALTH"→"AIR"→"AIR HEALTH"→"no display"
● When selecting "HEALTH" by remote controller, HEALTH function will be started up.
● When selecting "AIR" by remote controller, AIR function will be started up.
● When selecting "AIT HEALTH", AIR and HEALTH function will be started up.
● When there’s no display on remote controller, AIR and HEALTH function will be turned off.
SAVE Function:
Under cool mode, press SAVE button and the unit will operate under SAVE mode.
Dual-8nixie tube on remote controller displays "SE". Air conditioner will operate at auto speed. Set temperature can’t be adjusted.
Press SAVE button again to exit
SAVE mode. Air conditioner turn back to original set speed and set temperature.
● This function is applicable to partial of models.
8. X-FAN button
After pressing this button under cooling or dry mode, remote controller displays the character of "X-FAN" and X-FAN function is started
up. Press this button again to cancel X-FAN function. The character of "X-FAN" will disappear.
Note:
● After starting up X-FAN function, when turning off the unit, indoor fan will continue to operate for a while at low speed to dry the
residual water inside the indoor unit.
● When the unit operates under X-FAN mode, press "X-FAN" button can turn off X-FAN function. Indoor fan stops operation
immediately.
9. TEMP button
Press this button can see indoor set temperature, indoor ambient temperature or outdoor ambient temperature on indoor unit’s display.
Temperature is set circularly by remote controller as below:
● When selecting " " by remote controller or no display, temperature indicator on indoor unit displays set temperature.
● When selecting " " by remote controller, temperature indicator on indoor unit displays indoor ambient temperature.
● When selecting " " by remote controller, temperature indicator on indoor unit displays outdoor ambient temperature.
Note:
● Outdoor ambient temperature display may can’t be selected for some models. When indoor unit receives " " signal, it displays
indoor set temperature.
● Only for the model whose indoor unit has dual-8 display.
10. TIMER button
5s can adjust the time of TIMER ON. After each pressing of "+" or "-" button, time will increase or decrease half an hour. When holding
no display
(horizontal louvers stops
at current position)
(swing angle is dis-
played dynamically)
(swing angle is displayed dynamically)
no display