Gree GWH36LB-K3NTA5A - Page 18

15
7HFKQLFDO,QIRUPDWLRQ
Service Manual
● At OFF status, press this button once can set TIMER ON. Please refer to TIMER off for detailed operation. Cancel TIMER ON: Press
"TIMER" button again under TIMER ON status.
Note:
● Time setting range: 0.5-24 hours.
● Time interval between two operations can’t exceed 5s. Otherwise, remote controller will exit the setting status automatically.
11. TURBO button
When pressing this button under cooling or heating mode, air conditioner will enter into quick cooling or quick heating mode. The
character of "TURBO" is displayed on remote controller. Press this button again to exit turbo function and the character of "TURBO"
will be disappeared on remote controller.
12. SLEEP button
Press this button under cooling, heating or drying mode can start up sleep function." " icon will be displayed on remote controller.
Press this button again to cancel sleep function. " "icon on remote controller will be displayed.
13. LIGHT button
Press this button can turn off the light for indoor unit’s display. " " icon on remote controller will disappear. Press this button again to
turn on the light for indoor unit’s display. " " icon on remote controller will be displayed.
Child lock function
Press "+" and "-" buttons simultaneously can turn on or turn off child lock function.
When child lock function is started up, " " icon will be displayed on remote controller
three times, while remote controller won’t send signal.
Switchover function for temperature display
After turning off the unit by remote controller, press "-" button and "MODE" button simultaneously to switch between °C and °F .
1. After putting through the power, press " " button on remote controller to turn on the air conditioner.
2. Press " " button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3. Press "+" or "-" button to set your required temperature. (Temperature can’t be adjusted under auto mode).
4. Press " " button to set your required fan speed: auto, low, medium and high speed.
5. Press " " and " " button to select fan blowing angle.
ON/OFF
MODE
FAN
Function Introduction for Combination Buttons
Operation Guide
Replacement of Batteries in Remote Controller
cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position of "+" polar and "-" polar are
correct.
3. Reinstall the cover of battery box.
Note:
● During operation, point the remote control signal sender at the receiving window on indoor unit.
● The distance between signal sender and receiving window should be no more than 8m, and there
should be no obstacles between them.
remote controller should be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don’t use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there’s no display, please replace batteries.
signal sender battery
Cover of battery box
remove
reinstall