Removal Procedure
89
Steps Procedure
13. Remove PFC induction
14. Remove 4-way valve assy
15. Remove valve support sub-assy and expansion valve assy
4-way valve
assy
expansion
valve assy
valve support assy
PFC induction
Remove the screw connecting the PFC induction
and middle isolation sheet, and then remove the
PFC induction.
Unsolder the welding joint connecting the 4-way valve
assy with compressor suction and discharge port, the
valve with the outlet pipe of condenser. Then lift the
4-way valve assy to remove it.
(NOTE: Discharge the refrigerant completely before
unsoldering.)
Remove the screw connecting the valve support and
the chassis, and then remove the valve support assy.
Unsolder the welding joint connecting the electronic
expansion valve assy with the cut-off valve and the
condenser connection pipe, and then remove the e
xpansion valve assy.
To Next Page
Loading...
