Dissassembly Procedures/ Photoes
９．
１２．
１０．
１１．
29
８－１７
８－１８
８－１９８－２０
８－２１８－２２
8-23
8-24
8-25
Disassemble the aire outlet rear side plate assy
a. Firstly to remove the velveteen and
the left and right sides ' of liners .;
b. To screw off the bolts as shown in
the Fig. with screw driver.
Disassemble the left, right decoration plates assy
To screw off the bolts with screwdriver as shown in the fig.
of the swing motor
Disassemble the left, right sides plates foam sub-assy
Fig. Fig.
Fig. Fig.
Bolts
Bolt
Bolt
Bolt Bolt
Fig.
Fig.
Clasp
Fig.
Fixing screw
Right side plate foam sub-assy Left side plate foam sub-assy
According to the direction,
to take out the left, right sides plates foam sub-assy.
Disassemble motor assy
a.Pressing the clasp position where assorted with
front, rear propeller housing(Fig.8-23), then lift
up can take out the front propeller housing;
b. Holding the clasp position of rear propeller
housing (Fig.8-24) and lift it up, can take out
the rear propeller housing;
c.Then to loose the fixing bolts on the clutch
with special tools( Fig.8-25), then move the
clutch toward the louver, until can take out
the clutch and rotating axial assy;
d. To screw off the fixing screw on the louver
with special tool, and take out the louvers.
To Next Page
Loading...
