－8－
OPERATING METHODS
1). To select a place near the door and window, install the exhaust duct put the exhaust
duct out of the door, do not close the door and window tightly, leaving the space for
air flow, for example to open the window or the door, to keep the good ventilation.
2). Press "MODE" to select "COOL" mode.
3). Press "TEMP" to set the suitable temp.16℃-30℃.
4). Press "FAN" to select the suitable fan speed, (HIGH, MD, LOW).
When the unit is running in the COOL mode, in order to keep the good cooling effect,
please pay more attention to:
① If there is the direct sunlight near the window, please use the curtain to shield .
② Do not use other heat sources in the air conditioner room.
Please close the door and window, in order to obtain the better dehumidifying effect:
Press "MODE" , select the "DRY" mode, the unit will run in the "DRY" mode, at the
same time, the upper motor is running at the low speed, it is not adjustable.
When the air conditioner is used as the dehumidifier, it is no need to install the exhaust duct.
1). Press "MODE", to select the "FAN" mode.
2). Press "FAN ", to choose from the HIGH, MD, LOW fan speed options.
Press "MODE" to select the "AUTO" mode, the microcomputer process will
automatically choose the COOL, DRY mode, to ensure the indoor constant
temperature efficiency.
COOL
CAUTION
DRY
CAUTION
FAN
AUTO
WATER
DRAINAGE
When in "COOL" or "DRY" mode, the dew water will drain into the tank, when the tank gets
full, the buzzer will sound "Di, Di……"for eight times, LCD window shows error code "E4",
at the same time the unit will switch off, till there is no full of water, and the compressor will
stop for 3 minutes to restart, pull out the plug of the drainage pipe, take out the drainage pipe
from the set clamp, pour out the water inside the tank, then insert the plug to the drainage pipe,
in order to avoid the leakage, at the same time fix the drainage pipe on the set clamp, it is shown
as below:
Rear plate
Fix the drainage pipe on the set clamp
Drainage pipe
Press the"mode" button, select the heating mode, the LCD window shows" ".
HEATING
To Next Page
Loading...
