BACnet Protocol Gateway
15
Parameters that can be set: gateway IP address (IP address setting: numbers
of master unit can’t all be 0; if they are all 0, it indicates the whole network, such as
192.168.0.0
；
numbers of master unit can’t all be 1; if they are all 1, it indicates
broadcast address, such as 192.168.0.255. It is not suggested to be set by users.
Otherwise, the gateway pages will unable to access), Gateway subnet mask,
defaulted gateway,device name and device ID. Users can configurate it by
themselves according to actual circumstances.
Default parameters:
①
Access
platform:Third-party;
②
Access protocol:BACnet IP;
③
Communication port :47808;
④
OutTime:1000(ms).
After the parameter setting is completed, click Save and restart the gateway to
complete the configuration.
Caution! The default parameters should not be changed. Otherwise, the
gateway may not work normally.
To Next Page
Loading...
