AIR SOURCE HEAT PUMP WATER HEATER SERVICE MANUAL
17
Main interface
PRESET 1
blinks.
The ON icon
blinks.
Press the
TIMER button.
Press or to select
PRESET X
The hour value
of PRESET X
blinks.
Press the
TIMER button.
The minute
value of
PRESET X
blinks.
Press the TIMER button.
The OFF icon
blinks.
PRESET 1 or
PRESET 3
blinks.
Setting is complete
and PRESET X is
canceled.
Setting is
complete and
PRESET X is
started.
The PRESET mode runs circularly. The water heater starts to heat up water based on the preset
time and ambient temperature and stops one hour after the preset time.
4.6 Function Setting
4.6.1 i-KNOW
In the On state, press the i-KNOW button to select the i-KNOW function. To cancel this function,
press the i-KNOW button again.
4.6.2 RAPID
In the On state, press the RAPID button to select the RAPID function. The electrical heater is
started for heat up. To cancel this function, press the RAPID button again. Then electrical heater is
stopped.
Under the E-HEATER mode, users can press the RAPID button to switch to the HOTWATER mode.
To return to the E-HEATER mode, press the RAPID button again.
To Next Page
Loading...
