®
Fabra Hood • Form F 1
Document 471322
Model FGI/FGR Fabra Hood
Form F - Single Section with Filters
Throat length less than or equal to 72 inches
Assembly Instructions
Please read and save these instructions for future reference. Read carefully before attempting to assemble, install,
operate or maintain the product described. Protect yourself and others by observing all safety information. Failure
to comply with these instructions will result in voiding of the product warranty and may result in personal injury
and/or property damage.
Standard Assembly
Step 1 Fabra hood Form F 471322
HOOD END ASSEMBLY
(FEMALE RIB)
HOOD RAIL ASSEMBLY
SIDE FILTER
HOOD SUPPORT ANGLE
BASE ASSEMBLY
END FILTER
SIDE FILTER
HOOD END ASSEMBLY
(MALE RIB)
HOOD PANEL
Step 1 – Open crates and separate parts
Open the shipping crates and separate the parts according to the size of the unit, refer to Figure 1.
Step 2 – Place BASE ENDS and BASE SIDES
Place the two base ends and the two base sides in their approximate relationship to each other, see Figure 2. Fasten
together using three 1/4-20 fasteners per corner for 5 inch high base and four 1/4-20 fasteners per corner for 12 inch
high base.
NOTE: Fasteners should be hand tightened only until Step 4.
On some units where the difference between the hood width and throat width is greater than 32 inches, a reinforcing
plate is required in the corners of the base, refer to Figure 2, Detail A.
Figure 2 Fabra hood B #471321
BASE END
BASE SIDE
REINFORCING PLATE
DETAIL A
BASE END
BASE SIDE
IMPORTANT: For high wind rated hoods,
follow assembly instructions starting on page 5.
Figure 2
Figure 1
To Next Page
Need help?
General
