Ceiling Exhaust Fans 5
Installation for Joist Mounting Continued
4. Finish ceiling work. Ceiling hole should be aligned
with the inside edge of the flange. See Fig. 6.
ATTENTION
1. Before turning on the light, make sure the plug is
fully engaged.
2. Mount carefully so that light wiring is not pinched.
5. Insert the mounting springs into slots as shown and
mount grille to fan body. See Fig. 7 and Fig. 8.
6. For model SP-LP0511L, with light.
a. Insert the grille mounting spring on the wiring side
into the slot, insert the plug into the receptacle in
the housing.
b. Insert the other mounting spring into the slot and
mount the grille to fan body. See Fig. 7 and Fig. 8.
IMPORTANT
After finishing installation, fill gap between flange and
ceiling with caulk or other sealant to prevent
air leakage.
Fig. 6
Fig. 7
Fig. 8
Fig.11
Fig.10
Fig.9
Grille
Ceiling
Slot
Mounting
Spring
To Next Page
Loading...
