Why is my Greenheck Fan making excessive noise and vibrating?
Excessive noise or vibration in your Greenheck Fan can stem from several issues. Start by cleaning any dirt off the wheel and checking its balance, rebalancing if needed. Also, make sure the wheel is centered on the inlet cone. Finally, inspect the wheel and housing for any foreign objects; remove them and check for damage or unbalance.
Why has the airflow reduced in my Greenheck Fan?
Reduced airflow in your Greenheck Fan can be caused by several factors. First, check the system for high resistance due to improper operation of backdraft or control dampers, obstructions in the ductwork, or dirty filters. Also, airflow can be reduced if there is excessive dirt buildup on the wheel, so cleaning the wheel is recommended. Finally, ensure proper wheel alignment by centering the wheel on the inlet cone.
How to fix excessive noise or vibration in Greenheck Fan?
Excessive noise or vibration in your Greenheck Fan could stem from a few sources. A primary cause might be wheel unbalance, so start by cleaning all dirt off the wheel and checking its balance, rebalancing it in place if needed. Alternatively, the wheel might be improperly aligned and rubbing; in this case, center the wheel on the inlet. Lastly, check for any foreign objects in the wheel or housing, remove them, and inspect for any damage or unbalance.
Why is my Greenheck SQ Fan making so much noise?
Excessive noise in your Greenheck Fan can stem from several causes. It might be due to a wheel unbalance, which requires cleaning all dirt off the wheel and checking its balance, rebalancing if needed. Another cause could be that the wheel is improperly aligned and rubbing, so centering the wheel on the inlet cone might be needed. Also, check for any foreign objects in the wheel or housing and remove them, while also inspecting for damage or unbalance.
Why Greenheck SQ Fan has reduced airflow?
If your Greenheck Fan has reduced airflow, it could be due to several reasons. The system resistance might be too high; in this case, check the system for proper operation of backdraft or control dampers, obstructions in the ductwork, and dirty filters. Another cause could be the unit running backwards; correct this issue. Excessive dirt buildup on the wheel or improper wheel alignment can also cause reduced airflow; clean the wheel and center it on the inlet.
General| Model | SQ |
|---|---|
| Motor Type | TEFC (Totally Enclosed Fan Cooled) |
| Drive Type | Direct Drive |
| Housing Material | Galvanized Steel |
| Wheel Type | Backward Inclined |
| Voltage Options | 115/230V, 208-230/460V, 575V |
| Temperature Range | -40°F to 250°F |
To Next Page
