To Next Page

To Previous Page

Page 11

Cleaning

WARNING! Do not operate the unit unless

the following are properly installed: PCO

CELL, PURIFICATION PLATE, REAR FILTER

ASSEMBLY (with all three pieces in place), and

the REAR COVER.

CAUTION! The unit should be powered off and

the POWER CORD should be disconnected

whenever cleaning/disassembling/reassembling/

servicing.

Unit Exterior

Wipe down the exterior with a damp cloth or use

compressed air or a vacuum cleaner to remove

dust. A non-abrasive cleaner may be used on

the surfaces of the exterior, but do not let non-

alcohol based cleaners come in contact with the

IONIZATION NEEDLE at the left center of the

FRONT GRILLE.

Filter Assembly

Clean water or compressed air may be passed

through the lter assemblies or through the

individual parts of the lters when they are

disassembled. To disassemble the FILTER

ASSEMBLIES grasp the assemblies by the sides

of the rim around the lter and carefully separate

the rim from the FILTER ASSEMBLY. The three

lters (mesh, foam, and honeycomb) can then

be removed and cleaned separately. If using

water you must allow the lters to dry separately

before reassembly. When reassembling, the

HONEYCOMB FILTER goes in rst, then the

FOAM FILTER, and nally the thin MESH

FILTER. Then simply reattach the rim to the

FILTER ASSEMBLY.

Ionization Needle

Using a cotton applicator (Q-Tip), apply a small

amount of clear alcohol based cleaner (or rubbing

alcohol) to the IONIZATION NEEDLE. You may

also use compressed air to blow off any dust that

may accumulate near the IONIZATION NEEDLE.

Unit Interior

Using a damp cloth, a clear alcohol based cleaner,

or compressed air/vacuum cleaner carefully clean

the walls and components inside of the unit, after

completing the DISASSEMBLY procedures.

PCO Cell

Using compressed air or a vacuum blow/suck the

dust out of the PCO Cell. Do not use any liquid to

clean the PCO CELL.

Purication Plate

Using a 50/50 mix of warm water and clear

ammonia, soak the PURIFICATION PLATE from

1-8 hours. Using a soft-bristle brush, scrub the

metal center. Rinse thoroughly and allow to dry

completely before reinstalling.

Brand	GreenTech
Model	GT1500
Category	Air Cleaner
Language	English

GreenTech GT1500 User Manual

Table of Contents

Questions and Answers:

GreenTech GT1500 Specifications

Related product manuals