1 DESCRIPTION
1.1 PURPOSE
This machine is used to cut grass, light weeds, and
other similar vegetation at or around ground level. The
cutting plane must be approximately parallel to the
ground surface. You cannot use the machine to cut or
chop hedges, shrubs, bushes, flowers and compost.
1.2 OVERVIEW
Figure 1 - 19.
1
Rear handle
2
Lock-out button
3
Speed switch
4
Trigger
5
Auxiliary handle
6
Coupler
7
Edge guide
8
Cut-off blade
9
Guard
10
Screw hole
11
Release button
12
Lower shaft
13
Upper shaft
14
Positioning hole
15
Knob
16
Lower clamp
17
Battery release button
18
Spool cover
19
Spool
20
Tab
21
Line exit hole
22
Bump knob
23
Spool housing
24
Metal rod
A
Direction of rotation
B
Best cutting area
C
Dangerous cutting area
2 SAFETY
WARNING
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
WARNING
Remove the battery pack from the machine before
installation.
WARNING
Do not use accessories that are not recommended for
this machine.
3.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2 ATTACH THE GUARD
Figure 2.
WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a
Phillips head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw
holes on the trimmer head.
4. Tighten the screws.
3.3 ATTACH THE EDGE GUIDE
Figure 4.
NOTE
The edge guide can limit the cutting range of the
machine and decrease the risk of the damage caused
by the rotating cutting line.
4
English
EN
To Next Page
Loading...
