NOTE
Use only with the nylon cutting line of 2 mm diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into
the slot in the center rim of the spool. Make sure
that the line snaps into position in the slot.
3. With your finger between the lines, wind the lines
equally and tightly around the spool in the indicated
direction.
4. Put the lines in the guide slots.
5. Do not wind the lines beyond the edge of the spool.
5.5 REPLACE THE BUMP KNOB
Figure 19.
1. Push the tabs on the sides of the trimmer head at
the same time.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Hold the bump knob and pry it out with a metal rod
(not provided).
5. Put the new bump knob into the spool housing.
6 TRANSPORTATION AND
STORAGE
6.1 MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack and charge it.
• Assemble the blade guard.
6.2 STORE THE MACHINE
• Remove the battery pack from the machine.
• Make sure that children cannot come near the
machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine
for any damage.
7 TROUBLESHOOTING
Problem Possible Cause Solution
The ma-
chine does
not start
when you
push the
trigger.
No electrical
contact between
the machine and
the battery pack.
1. Remove battery
pack.
2. Check contact and
install the battery pack
again.
The battery pack
is depleted.
Charge the battery
pack.
The lock-out but-
ton and trigger
are not pushed
at the same
time.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to
start the machine.
7
English
EN
To Next Page
Loading...
