OPERATION
18
ADJUSTING THE POLE EXTENSION
• Disconnect the pole saw from the power supply.
• Align top and bottom section.
• Using a screwdriver to press in on locking tab.
• Slide top section over bottom one.
• When the desired length is achieved, rotate the collar counter-clockwise to secure.
NOTE: Extend the pole only to the length required to reach the limb being cut. Do not extend the handle
above waist height.
NOTE: Adjust your hand placement on the shaft of the pole saw to keep proper balance. Do not attempt to
use the pole saw at a length that does not allow you to achieve proper footing and balance at all times.
To Next Page
Loading...
