GreenWorks ST80L210 - English; Default Chapter; Table of Contents

1 Description.........................................4
1.1 Purpose.............................................................. 4
1.2 Overview........................................................... 4
2 Important safety instructions...........4
3 Symbols on the machine................... 5
4 Risk levels...........................................5
5 Service................................................ 6
6 Environmentally safe battery
disposal...............................................6
7 Proposition 65....................................6
8 Installation......................................... 6
8.1 Unpack the machine.......................................... 6
8.2 Attach the edge guide........................................ 7
8.3 Attach the guard.................................................7
8.4 Assemble the shaft.............................................7
8.5 Attach the auxiliary handle................................8
8.6 Install the battery pack.......................................8
8.7 Remove the battery pack................................... 8
9 Operation........................................... 8
9.1 Controls............................................................. 8
9.2 Start the machine............................................... 8
9.3 Stop the machine............................................... 9
9.4 Adjust the length of the cutting line.................. 9
9.5 Line cut-off blade.............................................. 9
9.6 Adjust the cutting diameter................................9
9.7 Operation tips.................................................... 9
9.8 Cutting tips ..................................................... 10
10 Maintenance.....................................10
10.1 General information.........................................10
10.2 Clean the machine........................................... 10
10.3 Replace the spool.............................................10
10.4 Replace the cutting line....................................11
11 Transportation and storage............ 11
11.1 Move the machine............................................11
11.2 Store the machine............................................ 12
12 Troubleshooting...............................12
13 Technical data..................................13
14 Limited warranty............................ 13
15 Exploded view..................................14
3
English
EN