GreenWorks ST80L210 - ATTACH THE AUXILIARY HANDLE; INSTALL THE BATTERY PACK; REMOVE THE BATTERY PACK; OPERATION

4
2
3
1
5
4. Turn the lower shaft until the button locks into the
positioning hole.
2
5. Tighten the knob.
LOOSE
N
5
TIGHTEN
1
8.5 ATTACH THE AUXILIARY
HANDLE
1. Remove the screws from the handle with a Phillips
screwdriver (not provided).
1
2. Attach the auxiliary handle and lower clamp on the shaft.
3. Set the auxiliary handle in the most comfortable in use
position.
4. Tighten the screws.
8.6 INSTALL THE BATTERY PACK
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
1
8.7 REMOVE THE BATTERY PACK
1. Push and hold the battery release button (1).
2. Remove the battery pack from the machine.
9 OPERATION
IMPORTANT
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
WARNING
Be careful when you operate the machine.
9.1 CONTROLS
9.2 START THE MACHINE
1. Push the lock-out button (2) and pull the trigger (1). Once
the machine is running you can release the lock-out
button.
8
English
EN