GREER COMPANY
GREER COMPANYGREER COMPANY
GREER COMPANY
Crane Systems
Crane SystemsCrane Systems
Crane Systems
GREER COMPANY 1918 EAST GLENWOOD PLACE SANTA ANA, CALIFORNIA 92705 PN W453201A 08/10/00
MicroGuard
®
434/500 CALIBRATION MANUAL TEL: 714) 259-9702 FAX: 714) 259-7626
5
OF
39
THE CALIBRATION
THE CALIBRATION THE CALIBRATION
THE CALIBRATION MODE
MODEMODE
MODE
Use of the functions described in this manual requires that the MicroGuard
®
434/500 System be in the
Calibration Mode of operation.
TO ENTER THE CALIBRATION MODE
TO ENTER THE CALIBRATION MODETO ENTER THE CALIBRATION MODE
TO ENTER THE CALIBRATION MODE
SIMULTANEOUSLY PRESS AND HOLD THE TEST
TESTTEST
TEST AND CRANE SETUP
CRANE SETUPCRANE SETUP
CRANE SETUP BUTTONS UNTIL PROMPTED
BY THE DISPLAY TO ENTER THE CALIBRATION CODE.
TO ENTER THE CALIBRATION CODE
TO ENTER THE CALIBRATION CODETO ENTER THE CALIBRATION CODE
TO ENTER THE CALIBRATION CODE
PRESS THE
DISPLAY ARROW KEYS IDENTIFIED AS: 1 6 3 4 IN THE SEQUENCE SHOWN
(REFER TO PAGE 4.)
NOTE
NOTENOTE
NOTE: IF THE WRONG SEQUENC
IF THE WRONG SEQUENCIF THE WRONG SEQUENC
IF THE WRONG SEQUENCE IS USED OR IF THE
E IS USED OR IF THE E IS USED OR IF THE
E IS USED OR IF THE ENTRY IS NOT COMPLET
ENTRY IS NOT COMPLETENTRY IS NOT COMPLET
ENTRY IS NOT COMPLETED
ED ED
ED
WITHIN 5 SECONDS,
WITHIN 5 SECONDS,WITHIN 5 SECONDS,
WITHIN 5 SECONDS, THE CALIBRATION ENTRY WILL BE ABORTED AND MUST BE REENTERED.
NOTE: IF A PICTURE
NOTE: IF A PICTURE NOTE: IF A PICTURE
NOTE: IF A PICTURE OF THE WORKING SCREE
OF THE WORKING SCREEOF THE WORKING SCREE
OF THE WORKING SCREEN APPEAR
N APPEARN APPEAR
N APPEARS,
S,S,
S, ENTER THE CALIBRATION MODE
AND THE CALIBRATION CODE AGAIN.
WHEN IN THE CALIBRATION MODE
WHEN IN THE CALIBRATION MODEWHEN IN THE CALIBRATION MODE
WHEN IN THE CALIBRATION MODE
THE TWO-BLOCK ALARM AND KICKOUT ARE OPERATIONAL. ALL OTHER ALARM KICKOUTS AND
AUDIO ALARMS WILL REMAIN INACTIVE UNTIL THE SYSTEM IS OUT OF THE CALIBRATION MODE.
ALL VISUAL WARNING ALARMS WILL REMAIN ACTIVE.
To Next Page
Loading...
Need help?
General