GREER COMPANY
GREER COMPANYGREER COMPANY
GREER COMPANY
Crane Systems
Crane SystemsCrane Systems
Crane Systems
GREER COMPANY 1918 EAST GLENWOOD PLACE SANTA ANA, CALIFORNIA 92705 PN W453201A 08/10/00
MicroGuard
®
434/500 CALIBRATION MANUAL TEL: 714) 259-9702 FAX: 714) 259-7626
8
OF
39
COMMAND 00 ERROR CODES
COMMAND 00 ERROR CODESCOMMAND 00 ERROR CODES
COMMAND 00 ERROR CODES
THIS COMMAND IS USED TO EXECUTE A SYSTEM SELF-TEST AND TO DETECT AND DISPLAY ANY
ERRORS PRESENT IN THE SYSTEM. THESE ERRORS ARE SHOWN BY MEANS OF AN ERROR CODE.
COMMAND 00 ERROR CODES
COMMAND 00 ERROR CODESCOMMAND 00 ERROR CODES
COMMAND 00 ERROR CODES
0.
ENTER THE CALIBRATION MODE AND CALIBRATION CODE, IF NOT ALREADY DONE.
REFER TO PAGE 5.
1.
CHOOSE MENU UP OR MENU DOWN AND GO TO 00 ERROR CODES ............
2 or 3
2 or 32 or 3
2 or 3
(IF NOT ALREADY DISPLAYED).
2.
START 00 ERROR CODES. ................................................................................................
1
11
1
(THE SYSTEM GOES THROUGH A SELF TEST IDENTIFYING ANY SYSTEM ERRORS,
WHICH ARE THEN DISPLAYED AS ERROR CODES.
3.
EXIT THE ROUTINE. ..........................................................................................................
6
66
6
REVIEW THE SAMPLE DISPLAY SCREEN ON PAGE 4
REVIEW THE SAMPLE DISPLAY SCREEN ON PAGE 4REVIEW THE SAMPLE DISPLAY SCREEN ON PAGE 4
REVIEW THE SAMPLE DISPLAY SCREEN ON PAGE 4.
Use the designated arrow key (
1, 2, 3, 4, or 6
1, 2, 3, 4, or 61, 2, 3, 4, or 6
1, 2, 3, 4, or 6
) appearing to the right of each step
when ENTERING or EXITING a COMMAND
and to CHOOSE, START, CONFIRM, ABORT, RESET, or ENTER an action.
To Next Page
Loading...
Need help?
General