GridConnect NET485 User Manual (English)

Other manuals for GridConnect NET485

Questions and Answers:

Mr. Tony RossAug 12, 2025

Why can I ping GridConnect NET485 but not Telnet to port 9999?

B
Brenda BrownAug 13, 2025
If you can ping the GridConnect Adapter but cannot Telnet to port 9999, it might indicate an IP address conflict on your network. To resolve this, turn off the device server and use the following commands in your computer's DOS prompt: 'ARP -D X.X.X.X' (replace X.X.X.X with the device server's IP address), followed by 'PING X.X.X.X' (again, using the device server's IP address). If you receive a response after the ping, it confirms a duplicate IP address. If there's no response, use the serial port to check if Telnet is disabled.

Colleen PachecoAug 16, 2025

What to do if GridConnect NET485 is not communicating with the serial device?

A
awolfAug 16, 2025
If the GridConnect Adapter isn't communicating with the serial device, the serial settings might be incorrect. Ensure that the serial settings for both the serial device and the device server match. The default settings for the device server are RS-232, 9600 baud, 8 character bits, no parity, 1 stop bit, and no flow control. For NET485, you must change the setting to RS422 or RS485.

Interface	RS-485
Product Type	Serial to Ethernet Converter
Ethernet	10/100 Mbps
Power Supply	5V DC
Operating Temperature	0°C to 70°C
Baud Rate	300 bps to 230.4 kbps
Operating Voltage	5V DC
Protocols	TCP, UDP, IP, ICMP, HTTP, DHCP, ARP, DNS
Connector Type	Terminal Block

Interface

RS-485

Product Type

Serial to Ethernet Converter

Ethernet

10/100 Mbps

Power Supply

5V DC

Operating Temperature

0°C to 70°C

Baud Rate

300 bps to 230.4 kbps

Operating Voltage

5V DC

Protocols

TCP, UDP, IP, ICMP, HTTP, DHCP, ARP, DNS

Connector Type

Terminal Block