GrillMaster 720-0737 - Wheel Assembly; Diagonal Bar Barrier Assembly; Cart Beam Assembly

11
B
S
5.
5.
5.
5. Wheel
Wheel
Wheel
Wheel Assembly
Assembly
Assembly
Assembly
a) Remove the nuts and washers which are
pre-assembled on the short axle, place the
wheels (C) on the Axle attached to Cart Leg,
Front Right (I) and Cart Leg, Back Right (J).
As show n in Fig. 7 .
b) Place washers and nuts to the axle and tighten
the nuts .
6.
6.
6.
6. Diagonal
Diagonal
Diagonal
Diagonal B
B
B
B ar
ar
ar
ar B
B
B
B arrier
arrier
arrier
arrier Assembly
Assembly
Assembly
Assembly
Loosen but do not remove the one screw
which is pre-assemble d on the Bottom Panel (B).
S ecure solid end of the Diagonal Bar Barrier (Y)
to the underside of the Front Panel (S), the n
secure other end of D i agonal Bar Barrier (Y) by
clipping the open hole onto the screw which
pre-assemble d on the B ottom P anel (B) . Tighten
the loosened screw. As show n in Fig. 8.
7.
7.
7.
7. C
C
C
C art
art
art
art Beam
Beam
Beam
Beam Assembly
Assembly
Assembly
Assembly
Insert the Cart Beam (R) into Cart Leg,
Back Left ( G ) and Cart Leg, Back Right (J) ,
aligning the holes. The Cart Beam (R) will fit
into holes as shown in Fig. 9.
Fig.
Fig.
Fig.
Fig. 9
9
9
9
Fig.
Fig.
Fig.
Fig. 7
7
7
7
Y
Fig.
Fig.
Fig.
Fig. 8
8
8
8
G
C
J
I
J
R