Grillo FX 27 - Transport and Lubrication; Warnings for Transport; Lubrication Chart

- 41 -
Check regularly that the battery voltage has not dropped below 12.5 Volts and if necessary,
recharge it.
WARNINGS FOR TRANSPORT
In case it should be necessary to lift the machine, check the machine’s weight on the
identification plate and use only suitable equipment (ramps, cranes, etc.).
If the machine is carried with a lorry or with a towed trailer, set the cutting deck at a low
position, apply the parking brake and tie the machine up to the means of transport using
ropes, cables, or chains.
LUBRICATION CHART
Type
Quantity
Engine oil
SAE 30
1,9 litres
Please change the oil and the
filter after the first 8 working
hours; after that every 100
hours.
Hydraulic
transmission
20W50
4,5 litres
Please change the oil after the
first 40 working hours; after that
every 200 hours or once a year.
Stabilizing device
OSO 10 hydraulic
0,2 kg
The perfect level is the half of
the oil reservoir capacity. Only
use hydraulic oil OSO 10.
Lubrication points
Lubricating grease
(EA3)
–
Every 40 hours grease the
blade hubs, the feed levers, the
cutting deck lifting
parallelogram, the pin
connected to 2 points joint of
the cutting deck, the stabilizing
cylinder ball-joints (follow the
chart).