INSTALLATION
1. In the U.S.A., this appliance must be installed in
accordance with the local code and the relevant national
code.
ANSI Z223.1/NFPA 54-National Fuel Gas Code,
ANSI/NFPA 58-Storage and Handling of Liquefied
Petroleum Gases
and Latest Local Codes where Applicable
In Canada, this appliance must be installed in
accordance with the local code and the relevant CGA
standards:
CAN/CSA-B149.1 LP Gas/Propane Installation Code,
CAN/CSA B149.2-Propane Storage and Handling
and Latest Local Codes where Applicable
2. The appliance must be located away from combustible
surfaces by at least 3m/10ft from each side, and 3m/10ft
from the rear.
3. Do not operate this appliance under any overhead roof
construction or foliage.
4. This appliance is for OUTDOOR USE ONLY, DO NOT
operate in garage, shed, balcony or other such enclosed
areas.
5. DO NOT restrict the flow of air to the appliance.
6. Keep the area surrounding the appliance free of
combustible materials, gasoline, and all flammable
liquids and vapours.
7. This appliance is not intended to be installed in, or on,
recreational vehicles and/or boats.
8. Do not leave the appliance unattended. Keep children
and pets away from the appliance at all times.
9. The use of alcohol, prescription or non- prescription
drugs may impair the consumer’s ability to properly
assemble or safely operate the appliance.
10. This appliance is not intended for and should never be
used as a heater.
11. The appliance will be hot during and after use. Protect
yourself with insulated oven gloves or mitts.
12. It is important when installing the burner to make sure
it is correctly centered and aligned with the orifice of
the valve. This is critical to the safe operation of the
appliance.
LP GAS CYLINDER PLACEMENT
12. Cylinders must be installed according to assembly
instructions. Do not store a spare cylinder under or
near this appliance.
13. The regulator hose when extended and attached to the
tank may become a tripping hazard. Care should be
taken when walking around the appliance.
3
To Next Page
Loading...
