Grimac G 11 - 6 Functioning; Switching on the Machine

40
ENGLISH
6 FUNCTIONING
Before proceeding with the start-up, you must check that all
parts are properly installed.
Check that:
• Thewatersupplytapisopen;
• Theoutlettapofthewatersoftenerisopen(andtheoper-
ation of loading the water softener has been carried out).
• Allthemachinepartsarecleanandworkingproperly;
• Checkthatthedriptrayemptiesandisinthecorrectpo-
sition.
• Checkthatthesteamdispensingknobsareclosed.
• Thatallofthebuttonsonthecontrolpanelare“OFF”.
6.1 Switching ON the Machine
Please refer to the whole section to learn more on how to op-
erate the machine.
In this case, let’s take the switching ON of the 2 unit machine
into consideration. Switching ON the 3 unit machine occurs
in the same way.
• Turntheswitchto«1»andwaitfortheboilertollup
(the warning light remains ON at the side of the selector
switch).
At the same time the warning light alongside the gauge
indicates the loading of the water into the boiler.
• On electronic machines the lling function features a
safety time after which all selections are disabled.
 lfitisexceeded,llingstopsandtheeventissignalledby
the blinking of the LEDs in the push-button panel.
To reset the machine, switch it o and on again.
• Once the loading has nished, position the selector
switch to the “2” position and wait 30 minutes for the
machine to heat up.
During this period, you should operate the steam knobs
and the dispensing group buttons, for few seconds, to
eliminate any air bubbles.
• Checkthatthepressureontheappropriategaugedoes
notexceed0.8bar-1bar.Ifnecessary,adjustthepres-
sure as described in paragraph 5.3.
Note: before turning the machine ON for
the rst time or when using it after a pro-
longed period of inactivity, it is necessary
to ll and rinse the water network. Carry
out 3 rinsing cycles dispensing hot water
fromtherelativewand;fordispensinghot
water follow the procedure as indicated in
sections 6.3.1 and 6.3.2.