Grimac G 11 - Coffee; Loading Coffee; Dispensing Coffee; Dispensing Coffee (Key Machine)

41
ENGLISH
6.2 Coee
On every Grimac appliance, the coee dispensing procedure
iseasyandquick;adeliciouscoeecanbetastedafterfew
steps.
Before dispensing coee, check all components are prop-
erly clean. Refer to paragraph 9 for the correct cleaning and
maintenance of the appliance. Refer to chapter 8 for the cor-
rect cleaning and maintenance of the machine.
6.2.1 Loading coee
The method for loading coee is the same for all machines.
Inthiscase,forexample,a2unitmachineisutilised.
Place a dose or ground coee in the lter.
Shake the coee a little in order to distribute it evenly and
press it slightly with the tamper.
If necessary, clean the edge or the lter to guarantee a bet-
ter sealing and a longer life to the undercup gasket.
Insert the lter holder and screw it
tightly in its seat.
Check that the lter holder and the
undercup gasket seat tightly.
.
Place 1 or 2 cups under the spout/s
dispenser/s, depending on the dos-
es and the lter holder utilised.
 Warmcupsavour a creamy cof-
fee.
6.2.2 Dispensing coee
(key machine)
After loading the lter holder, dispense the coee. For man-
ual machines, controlling the quantity of coee in a small
cup depends on the operator’s sensitivity.
This way, the preferred amount of coee can be brewed each
time.
Note: Each dispensing group has its own dis-
pensing control unit which must be managed
autonomously.
In this case, let’s take the dispensation of the single unit ma-
chine into consideration.
The dispensation of the other units happens identically.
Place the small cup under the dispensing spout.
Press the button above the group
to start brewing coee.
When the desired quantity of cof-
fee has been obtained, press the
switch again to stop the brewing.
Note: In this case, you can adjust the length
of the coee according to your customer’s
needandtothesizesofthesmallcup;ifthe
brewing is not stopped manually, the cof-
fee may spill out of the small cup.
When brewing ends, leave the lter holder in its seat until
thenexttimeyouuseit.
Before making coee again, release the lter holder from
the brew head and throw the grounds away into the knock
out drawer.
Empty the drip tray often and ensure that
it has been reinserted into the correct posi-
tion.