Grizzl-E Mini - Page 17

17
Under Voltage:
1. Unplug the charging connector from your EV.
2. Wait 1-2 minutes and then switch the upstream circuit breaker back to the “ON” position
3. Confirm the Fault light is no longer present.
4. Consult an electrician about the supply voltage if the error persists.
Missing Diode:
1. Unplug the charging connector from your EV.
2. Wait 1-2 minutes and then switch the upstream circuit breaker back to the “ON” position
3. Confirm the Fault light is no longer present.
4. Contact United Chargers Technical Support if the error persists.
Ground Fault
1. Unplug the charging connector from your EV.
2. Wait 1-2 minutes and then switch the upstream circuit breaker back to the “ON” position
3. Confirm the Fault light is no longer present.
4. Contact United Chargers Technical Support if the error persists.
Over Temperature:
1. Unplug the charging connector from your EV.
2. Unplug the EVSE from the outlet.
3. Allow 1 hour for interior electronics of Mini Grizzl-E to cool down.
4. Plug the EVSE back into the outlet. Conrm the fault light is no longer present.
5. Keep Mini Grizzl-E out of the sun or warm places when charging. Touch surface of
enclosure to check if unit is too hot.