MODEL G0441
3 HP CYCLONE
MANUAL UPDATE
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#TR8039 PRINTED IN TAIWAN
Improvements to this machine were made since the manual was originally printed, and this update covers
those changes. Keep this update with your Owner's Manual in case you ever need to refer to it. If you have
questions, contact Tech Support at (570) 546-9663 or by email at
techsupport@grizzly.com.
ON/OFF
TIMER
2H
4H
8H
RUN POWER
OVER
REMOTE CONTROL
SWITCH
220 VOLT
MAIN
SWITCH
Larger Impeller & Blower
We increased the size of the impeller from 15"
to 15
1
⁄2" for improved performance. We also
increased the size of the blower to accomodate
the new impeller.
The new part number for the 15
1
⁄2" impeller is
P0441014A. The new part number for the blower
is P0441018A.
Improved Magnetic Switch
We improved the remote controlled magnetic
switch since the manual was originally printed.
The new switch features an overload device that
requires the cyclone to be restarted after it has
been overloaded. The new features of the switch
are described below:
POWER: Lights up when there is power to the
machine.
RUN: Lights up when the machine is running.
OVER: Lights up if the machine has been over-
loaded. Machine will not start again until it has
been reset at the main switch.
To reset the machine from the overload state, turn
the main switch OFF, then ON
.
To Next Page
Need help?
General
