EasyManuals Logo

Grizzly G0555 Manual

Grizzly G0555
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Model G0555
Extension Block Kit
Grizzly’s Model H3051 Extension Block Kit
(shown in
Figure 1) increases the cutting height
of the Model G0555 Bandsaw to 12".
To install the Extension Block Kit:
1. Disconnect the bandsaw from the power
source!
2.
Open the wheel covers and remove the
blade per manual instructions.
3. Remove the left-side blade guard (Figure 2).
4. Remove the power switch assembly (Figure
2
). DO NOT disconnect the wiring and wait
until
Step 12 to remove the guide post
assembly.
5. Have an assistant support the upper arm
assembly
(Figure 3), then loosen the nut and
slide the bolt out. Remove the upper arm and
set it aside. Note
—The upper arm is pinned
to the base. If removal is difficult, carefully
rock it loose.
6. Place the extension block onto the base pins.
7. Have an assistant place the upper arm onto
the extension block pins and hold it in place
(Figure 4).
8. Place a washer over the long extension bolt
and slide the bolt down through the exten-
sion block.
Figure 1. Extension Block Kit.
Figure 2. Power switch and left side blade
guard.
Figure 3. Loosening bolt while an assistant sup-
ports the upper arm assembly.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
Power
Switch
Left-side
Blade
Guard

Other manuals for Grizzly G0555

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Grizzly G0555 and is the answer not in the manual?

Grizzly G0555 Specifications

General IconGeneral
Cutting Capacity Width13-1/2 in.
Cutting Capacity Height6 in.
Table Size14 in. x 14 in.
Table Tilt45° right, 10° left
Dust Port Size4 in.
Motor1 HP, 110V/220V, single-phase, TEFC

Related product manuals