-6-
Model G0592 (Mfd. Since 01/23)
P. Coolant Pump Switch: Turns coolant pump
ON.
Q. Emergency Stop/Off Button: Interrupts
power to system and turns motor OFF. Twist
button until it pops out to re-energize system.
Also works as standard Off button.
Note: Bandsaw has automatic shut-off (limit
switch) that turns machine OFF at completion
of cutting arc.
R. Start Button: Turns main motor ON and acti-
vates moving parts.
Control Panel
Figure 7. Control panel components.
P
Q R
S
T
U
S. Power Light: When lit, indicates system is
energized and machine is ready to operate.
T.
Feed Rate Dial: Fine tunes rate at which
blade feeds into workpiece by controlling
hydraulic valve. Range is from 0 (slowest) to
9 (fastest).
U. Feed Control Dial: Turning dial left lowers
headstock at feed rate you have set. Turning
dial fully right locks headstock in position.
To Next Page
